Cardax FT Controller – Download as PDF File .pdf), Text File .txt) or read online. Installation Guide. Cardax FT Controller CAUTION This equipment contains components that can be damaged by electrostatic discharge. Ensure both you. The Gallagher Controller supports the following door readers: > Cardax IV Prox (Mifare, kHz, TIRIS). > Cardax IV Prox Plus (Mifare, kHz,. TIRIS).

Author: Dasida Kigajind
Country: Morocco
Language: English (Spanish)
Genre: Software
Published (Last): 28 January 2007
Pages: 150
PDF File Size: 13.12 Mb
ePub File Size: 18.75 Mb
ISBN: 593-3-15464-420-9
Downloads: 67502
Price: Free* [*Free Regsitration Required]
Uploader: Vugal

Changes or modifications not expressly approved by Gallagher Security Management Systems could void the user’s authority to operate this equipment.

The In-service relay is used to signal an external alarm if the Controller fails. Standard and High Specis a processing board for an intruder alarm and access control system.

This port is provided for external communications to be connected to the system. The red Run LED flashes in the following sequence: Both variants of the Controller can operate on their own, or can have an optional Reader Module part number C or C connected.

Boot code monitor running. Then, as it has no configuration, it will not connect to the FT server until the primary ethernet link is connected. This indicates the Cardax FT Controller is waiting for database information to be downloaded from the Server.

Turn on the power supply. Purpose of this presentation This presentation introduces: On startup configuration and the IP address is deleted.


There is a proprietary serial communication protocol between the two boards. In the event of a catastrophic failure, after approximately 60 seconds the In-Service relay opens.

Cardax FT Version 5.

Cardax Ft Controller pdf

The sequence completes fairly quickly but it is important you ensure the LED finishes indicating the “normal running” sequence. Cardax FT Key Strengths. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Install the component identification decal inside the Cardax FT Cabinet door.

The Settings in bold specify the default new installation startup 600. This picture is not to scale, therefore cardxa the measurements provided.

However, this DC voltage out will be approximately 1 volt lower than the voltage supplied to the Cardax FT Controller The cardwx titled “Run LED” later in this Installation Note details the different meanings of the various flash sequences.

The Cardax FT Cabinet should be installed cardaxx a secure, internal location. Refer to Component layout within this Installation Note for the location of the serial socket. The rear optical tamper detector will sense if the Cabinet is removed from its mounting position.

When the Controller has a Reader Module connected, it receives information from the Reader Module about access requests and instructs the Reader Module to carry out the required function. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Related Posts  MOBILGREASE XHP 222 PDF

Cardax Ft Controller 6000pdf

Gallagher Controllers Overview The Gallagher Controllers are intelligent field controllers, programmed to make access control and intruder alarm decisions in the field, independent of the Gallagher Command Center. The following initialisation procedures are detailed in the later section titled “Initialisation”: Cardax FT for Airport Security.

On-board connections are provided for: Looking at the Controller it will be obvious cardas the there is no ethernet activity on either ethernet connection, as the RJ45 connector LEDs will not be operating, and the Controllers run LED will be in 2 flash. Controller The Gallagher Controller is specifically designed to support catdax controlled doors and integrated intruder alarms.

Operating temperature Humidity Maximum number of Published on Oct View 1.

An upgrade of the Controller software via a USB memory stick is complete and the USB drive must be removed for installation to complete. This operation can only be reset by the factory of manufacture.